Figure 5-22. Intercooler to Separator Line, Replace

Figure 5-23. Third Stage Inlet Line, Replace.

TM-5-4310-387-14 Compressor Unit Diesel Engine Driven 20 CFM 3200 PSI Model K-20-D Manual
Page Navigation
176

TM 5-4310-387-14 5-19. Lines and Fittings (Cont). f. Replace Intercooler to Separator Line. (figure 5-22) WARNING Cleanliness is imperative in maintaining and handling diving air system components. All tools and parts must be kept free of oil, grease, rust, or other contamination in accordance with Chapter 4, Section VI of this manual. Foreign substances within an assembly could result in equipment failure and possible injury or death to personnel. Ensure that all air lines and components removed or openings into the air system that provides breathing air are covered with a plastic bag and secured with a rubber band or taped shut. Small components should be stored in a plastic bag and sealed. Failure to do so will cause air system to become contaminated and could result in injury or death to the diver. (1) Loosen two connector nuts (1) and remove line (2). (2) Install line (2) and tighten two connector nuts (1). Figure 5-22. Intercooler to Separator Line, Replace. 5-52

Privacy Statement
Press Release
Contact