APPENDIX C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LISTS

Section IV. MAINTENANCE ALLOCATION CHART - TM-5-4310-389-14_349

TM-5-4310-389-14 Air Compressor 5.1 CFM Diesel Engine Driven Model KA7-DA Manual
Page Navigation
337

TM-5-4310-389-14 APPENDIX C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LISTS SECTION I. INTRODUCTION C-1 SCOPE. This appendix lists components of end item and basic issue items for the K-20, Diving Air Compressor to help you inventory items required for safe and efficient operation. C-2 GENERAL. The Components of End Item and Basic Issue Items Lists are divided into the following sections: a. Section II. Components of End Item. This listing is for informational purposes only, and is not authority to requisition replacements. These items are part of the end item, but are removed and separately packaged for transportation or shipment. As part of the end item, these items must be with the end item whenever it is issued or transferred between property accounts. b. Section III. Basic Issue Items. These are the minimum essential items required to place the K20, Diving Air Compressor in operation, to operate it, and to perform emergency repairs. Although shipped separately packaged, BII must be with the K-20, Diving Air Compressor, during operation and whenever it is transferred between property accounts. This manual is your authority to request/ requisition replacement BII, based on TOE/MTOE authorization of the end item. C-3 EXPLANATION OF COLUMNS. The following provides and explanation of columns found in the tabular listings: a. Column (1) Figure and Item Number. This column indicates the figure and item number of the RPTSL where the item is shown. b. Column (2) National Stock Number. Indicates the National stock number assigned to the item and will be used for requisitioning purposes. c. Column (3) Description. Indicates the Federal item name and, if required, a minimum description to identify and locate the item. The last line for each item indicates the CAGE (in parentheses) followed by the part number. d. Column (4) Unit of Measure (U.M). Indicates the measure used in performing the actual operation/maintenance function. This measure is expressed by a two character alphabetical abbreviation (e.g., ea, in, pr). C-1

Privacy Statement
Press Release
Contact