APPENDIX C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS

SECTION II. COMPONENTS OF END ITEM - TM-5-4310-393-14_169

TM-5-4310-393-14 Air Compressor Diesel Engine Driven 20 CFM 3200 PSI Model KA7-DA Manual
Page Navigation
159

TM 5-4310-393-14 APPENDIX C COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS SECTION I. INTRODUCTION C-1. Scope. This appendix lists components of end item (COEI) and basic issue items (BII) for the 5.0 CFM Reciprocating Compressor Unit, model CAPITANO-PD to help you inventory items required for safe and efficient operation. C-2. General. The Components of End Item and Basic Issue Lists are divided into the following sections: a. Section II. Components of End Item This listing is for informational purposes only, and does not give authority to requisition replacements. These items are part of the end item, but are removed and separately packaged for transportation of shipment As part of the end item, these items must be with the end item whenever it is issued or transferred between property accounts. b. Section III. Basic Issue Items. These are the minimum essential items to place the 5.0 cfm Air Compressor, Model CAPITANO-PD in operation, to operate it, and to perform emergency repairs though shipped separately, the Basic Issue Items must be with the 5.0 cfm Air Compressor, Model CAPITANO-PD during operation and whenever it is transferred between property accounts This manual is your authority to request or requisition replacement Basic Issue Items, based on the Table of Organization and Equipment authorization of the end item. C-3. EXPLANATION OF COLUMNS. The following provides an explanation of the columns found in the tabular listings: Column (1), Item Number indicates the figure and item number of the RPSTL where the item is shown. Column (2), National Stock Number, indicates the National Stock Number assigned to the item. This will be used for requisitioning purposes Column (3), Description, indicates the Federal Item Name for the item If required, a minimum description also provided to identify and locate the item. The last line for each item in the column identifies CAGEC (in parentheses) followed by the manufacturer's part number. Column (4), Unit of Measure (UM), indicates the unit of measure for the quantity that Column (5) identifies. This is expressed as a two character alphabetic expression (e.g., each, in, pr). Column (5), Quantity Required (Qty Reqd), indicates the quantity of the item authorized to be used on the equipment C-1

Privacy Statement
Press Release
Contact