TM 5-4310-452-14
5-27. BAFFLE AND OIL COOLER SUPPORTS REPLACEMENT (Con't).
2.
Remove air intake connector (see paragraph 4-33).
3.
Remove fuel/water separator (see paragraph 4-27).
4.
Remove 3 self-locking screws (6) and nuts (7) from side baffle assembly (5) and storage box (18). Discard self-
locking screws and nuts.
5.
Remove 3 screws (4) and side baffle assembly (5) from rear baffle assembly (1).
6.
Remove 2 screws (19) from front baffle assembly (1). Remove 3 self-locking screws (20) and nuts (2). Remove
front baffle assembly (1) from trailer. Discard self-locking screws and nuts.
7.
Remove electrical bushing (3) from rear baffle assembly (1).
8.
Remove oil filter base and bracket (see paragraph 4-85).
9.
Remove oil cooler (see paragraph 4-17).
10, Disconnect and remove all cables, electrical wiring harnesses, lines, and hoses that pass through, or are attached to
front wall baffle (9).
11, Remove 4 self-locking screws (8), nuts (14), 2 covers (15), and gaskets (16 and 17) from front wall baffle (9). Discard
gaskets, self-locking screws, and nuts.
12, Remove 22 screws (10) and front wall baffle (9) from trailer.
13. Remove 4 screws (11) from left and right oil cooler supports (12 and 13). Remove left and right oil cooler supports
from trailer.
b.
INSTALLATION
1.
Position left and right oil cooler supports (12 and 13) in place and install 4 screws (11) in left and right oil cooler
supports.
2.
Position front wall baffle (9) in place and install 22 screws (10).
3.
Install 2 new gaskets (16 and 17), covers (15), 4 new self-locking screws (8), and nuts (14) on front wall baffle (9).
4.
Install and connect all cables, electrical wiring harnesses, lines, and hoses that pass through or are attached to front
wall baffle (9).
5.
Install oil cooler (see paragraph 4-17).
6.
Install oil filter base and bracket (see paragraph 4-85).
7.
Install electrical bushing (3) in rear baffle assembly (1).
8.
Position front baffle assembly (1) in place and install 2 screws (19).
9.
Install 3 new self-locking screws (20) and nuts (2) in rear baffle assembly (1).
10. Position side baffle assembly (5) in place and install 3 screws (4).
11. Install 3 new self-locking screws (6) and nuts (7) in side baffle assembly (5) and storage box (18).
5-62