SECTION I
INTRODUCTION
a. Source, Maintenance and Recoverability
1. Scope
Codes (SMR).
This manual lists repair parts and special
(1) Source Code, indicates the selection
tools required for the performance of organiza-
status and source for the listed item. Source
tional maintenance of the lubricating and
codes are:
servicing unit.
Code
Explanation
2. General
Applied to repair parts which are stocked
P
a. The Repair Parts List is arranged as
in or supplied from DSA/GSA or Army
follows:
Supply system, and authorized for use at
indicated maintenance categories.
(1) Individual parts and major assem-
Applied to repair parts which are not pro-
M
blies are listed alphabetically by item name
cured or stocked but are to be manufac-
within the numbered functional groups.
tured at indicated maintenance categories.
(2) Assembly components and subassem-
Applied to assemblies which are not pro-
A
blies are indented and listed alphabetically by
cured or stocked as such but are made up
item name under major assemblies.
of two or more units, each of which
b. This Repair Parts and Special Tools List
carry individual stock numbers and de-
scriptions and are procured and stocked
is divided into the following sections:
and can be assembled by unit8 at indi-
(1) Prescribed Load Allowance (PLA)--
cated maintenance categories.
Applied to parts and assemblies which are
X
parts quantitatively allocated for initial stock-
not procured or stocked, the mortality
age at the organizational level. This is a man-
of which is normally below that of the
datory stockage allowance.
applicable end item, and the failure of
which should result in retirement of the
(2) Special Tools, Test and Support
end item from the supp1y system.
Equipment--Section III. A list of special tools,
test and support equipment authorized for the
Applied to repair parts which are not pro-
X1
cured or stocked, the requirement for
performance of maintenance at the organiza-
which will be supplied by use of the next
tional level. (Not Applicable)
higher assembly or components.
(8) Repair Parts--Section IV. A list of
X2
Applied to repair parts which are not
repair parts authorized for the performance
stocked. The indicated maintenance cate-
of maintenance at the organizational level.
gory requiring such repair parts will
(4) Federal Stock Number and Refer-
attempt to obtain them through canni-
balization; if not obtainable through
cannibalization, such repair parts will be
eral stock numbers followed by reference num-
requisitioned with supporting justifica-
bers in ascending alpha-numeric sequence,
tion through normal supply channels.
c-referenced to index number.
Applied to repair parts authorized for local
C
procurements. If not obtainable from
3. Explanation of Columns
local procurement, such repair parts will
The following provides an explanation of
be requisitioned through normal supply
columns in the tabular lists in Sections II,
channels with a supporting statement of
III, and IV:
nonavailability from local procurement.
iii
