TM 55-1905-223-24-8
i. Slide motor (20) toward compressor drive sheave (7) and remove vee belts (8).
j. Remove motor (20) from motor mounting rail (10).
k. Remove two bolts (24) and washers (25) and remove pulley (9) from motor shaft.
l. Remove the woodruff key from spline in motor shaft.
______________
REPLACEMENT
a. Place woodruff key in motor shaft spline and slide pulley (9) on motor shaft.
b. Secure pulley (9) on motor shaft with two bolts (24) and washers (25).
c. Set motor (20) on motor mounting rail (10).
d. Install the four motor mounting bolts (21), nuts (22), and washers (23). Do not completely tighten.
e. Install vee belts (8).
f. Adjust vee belt tension by sliding motor (20) away from compressor drive sheave (7). Use adjust
NOTE
New belts should be frequently monitored, as some new belts have a tendency to stretch.
g. Tighten the four motor mounting bolts (21) and nuts (22) firmly.
h. Place conduit box gasket (16) against motor frame.
i. Place motor leads through hole in replacement conduit box (17).
j. Align conduit box holes with those in motor frame and fasten conduit box (17) to motor with four studs
(13).
k. Install screw (14) in grounding lug (15).
1. Remove tags and make electrical connections.
m. Install conduit box gasket (18) and cover (19) with four acorn nuts (12).
2-15