TM 9-4310-397-14
CAUTION
Flywheel and flywheel housing are heavy. Use care when removing.
(c)
Remove remaining two cap screws (1) and install them into the tapped holes (3), to push the flywheel (4)
off crankshaft (5).
(2)
Housing.
(a)
Remove eight 3/8 inch cap screws (Figure 6-19, 1), and four 5/8 inch cap screws (2), from housing (3).
(b)
Remove flywheel housing (3) and gasket (4). Discard gasket.
(c)
Remove all old gasket (4) material from flange faces.
Figure 6-19. Flywheel Cover
c
Repair. Repair is limited to replacement of damaged flywheel or housing.
d
Installation.
(1)
Install flywheel housing.
(a). Install new gasket (Figure 6-19, 4) (item 51, appendix H).
(b). Install flywheel housing (3) on cylinder block using eight 3/8 inch cap screws (1), and four 5/8 inch cap
screws (2). The shorter screws are used at the top holes.
(c). Torque 3/8 inch screws (1) to 35 lb-in. (50 Nm) and 5/8 inch screws (2) to 167 lb-in (230 Nm).
6-19
