TM 3-1040-244-35P
SECTION I
INTRODUCTION
1. Scope
Code
Explanation
which are not subject to the provisions of AR
This manual lists repair parts, special tools, and special
380-41.
purpose test equipment required for the performance of
P10
Assigned to items which are NSA design controlled:
direct support, general support, and depot maintenance
special tools, test, measuring, and diagnostic
of the AN-M4B and ANM4C Compressors.
equipment for COMSEC support, which are
accountable under the provisions of AR 380-41,
2. General
and which are stocked and supplied by the Army
This repair parts and special tools list is divided into the
COMSEC Logistic System.
following sections:
M
Repair parts, special tools, and test equipment
which are not procured or stocked, as such, in
the supply system but are to be manufactured at
a. Repair Parts Section II. A list of repair parts
indicated maintenance levels.
authorized for the performance of maintenance at the
A
Assemblies which are not procured or stocked as
direct support, general support, and depot level in figure
such, but are made up of two or more units.
and item number sequence.
Such component units carry individual stock
b. Special Tools, Test aced Support Equipment
numbers and descriptions, are procured and
Section III. Not applicable.
stocked separately and can be assembled to
c. Federal Stock Number and Reference Number
form the required assembly at indicated
Index Section IV. A list of Federal stock numbers in
maintenance categories.
X
Parts and assemblies that are not procured or
ascending numerical sequence followed by a list of
stocked because the failure rate is normally
reference
numbers
in
ascending
alphanumeric
below that of the applicable end item or
sequence, cross-referenced to the illustration figure
component The failure of such part or assembly
number and item number.
should result in retirement of the end item from
the supply system.
3. Explanation of Columns
X1
Repair parts which are not procured or stocked.
The following provides an explanation of columns in the
The requirement for such items will be filled by
tabular lists in Sections II and IV:
the next higher assembly or component.
X2
Repair parts, special tools, and test equipment
which are not stocked and have no foreseen
a. Source,
Maintenance
and
Recoverability
mortality. The indicated maintenance category
Codes (SMR) Column.
requiring such repair parts will attempt to obtain
(1) Source code indicates the selection status
the parts through cannibalization or salvage, the
and source for the listed item. Source codes used are:
item may be requisitioned with exception data,
from the end item manager, for immediate use.
Code
Explanation
G
Major assemblies that are procured with PEMA
P
Repair parts, special tools, and test equipment
funds for initial issue only as exchange
supplied from the GSA/DSA, or Army supply
assemblies at DS and GS level.
These
system, and authorized for use at indicated
assemblies will not be stocked above the DS and
maintenance categories.
GS level or returned to depot supply level.
P2
Repair parts, special tools, and test equipment
which are procured and stocked for insurance
NOTE
purposes because the combat or military
Cannibalization or salvage may be
essentiality of the end item dictates that a
used as a source of supply for any
minimum quantity be available in the supply
items source coded above except the
system.
P9
Assigned to items which are NSA design controlled:
coded XI.
unique repair parts, special tools, test,
(2) Maintenance code indicates the lowest
measuring, and diagnostic equipment, which are
category of maintenance authorized to install the listed
stocked and supplied by the Army COMSEC
item. The maintenance level codes are:
Logistic System and
2