17. Carburetor
a. Insert a new gasket and assemble carburetor to
intake port with two screws.
b. Refer to section on Carburetor Adjustment,
page 6, for carburetor adjustment procedure.
18. Governor Arm and Linkage
a. Insert carburetor linkage in throttle arm.
b. Connect governor arm to carburetor linkage and
slide governor arm onto governor shaft.
c. Position governor spring in speed control disc
d. Before tightening clamp bolt, turn shaft counter-
clockwise as far as possible with a pair of pliers,
pull arm as far as possible to left (away from
carburetor), tighten nut and check for freedom
of movement.
Figure 32
Torquing Flywheel Nut
19. Slower Housing and Fuel Tank
B - Bar
C - Flywheel
a. The engine is now ready for blower housing,
cylinder baffles and head baffle. These parts
16. Breaker Points
are fastened to engine by 1/4"cap screws which
a. Install push rod.
attach to cylinder head and bearing plate.
b. Fasten breaker in place with two screws.
b. Gasoline fuel tank and brackets are installed at
the same time as baffles and shrouds.
c. Place cover gasket in. position and attach
magneto lead.
c. Connect fuel line between filter and carburetor.
d. Set breaker gap at .020. For precision ignition
FINAL ADJUSTMENTS
setting refer to Ignition Section, page 9.
e. Make final adjustments before installing breaker
1. Refer to Starting Instruction on page 3.
point cover. Be sure breaker lead grommet is in
place.
2. Follow instructions in Service Procedure Section for
final adjustments of engine.
78