INTRODUCTION
Code
Explanation
Scope
P
Applied to repair parts which are stocked in or
This manual lists repair parts required for the
supplied from DSA/GSA or Army supply sys-
tem, and authorized for use at indicated
performance of organizational maintenance of
maintenance categories.
the air compressor.
Applied to repair parts which are not procured
M
or stocked but are to be manufactured at in-
2. General
dicated maintenance categories.
Applied to assemblies which are not procured
A
a. The Repair Parts List is arranged as fol-
or stocked as such but are made up of two
lows:
or more units, each of which carry individual
(1) Individual parts and major assemblies
stock numbers and descriptions and are pro-
are listed alphabetically by item name within
cured and stocked and can be assembled by
the numbered functional groups.
units at indicated maintenance categories.
X
Applied to parts and assemblies which are not
(2) Assembly components and subassemblies
procured or stocked, the mortality of which
are indented and listed alphabetically by item
is normally below that of the applicable end
name under major assemblies.
item, and the failure of which should result
in retirement of the end item from the supply
b. This Repair Parts and Special Tools List
system.
is divided into the following sections:
XI
Applied to repair parts which are not procured
(1) Prescribed Load Allowance (PLA)--
or stocked, the requirement for which will be
supplied by use of the next higher assembly
or components.
quantitatively allocated for initial stockage at
X2
Applied to repair parts which are not stocked.
the organizational level. This is a mandatory
The indicated maintenance category requiring
stockage allowance.
such repair parts will attempt to obtain them
(2) Special Tools, Test and Support Equip-
through cannibalization; if not obtainable
ment--Section III. A list of special tools, test
through cannibalization, such repair parts will
and support equipment authorized for the per-
be requisitioned with supporting justification
through normal supply channels.
formance of maintenance at the organizational
Applied to repair parts authorized for local pro-
C
level (not applicable).
curements. If not obtainable from local pro-
(3) Repair Parts for Organizational Mainte-
curement, such repair parts will be requisi-
tioned through normal supply channels with a
thorized for the performance of maintenance at
supporting statement of nonavailability from
local procurement.
the organizational level.
Applied to major assemblies that are procured
G
(4) Federal Stock Number and Reference
with PEMA (Procurement Equipment Missile
Army) funds for initial issue only to be used
Stock numbers followed by reference numbers
as exchange assemblies at DSU and GSU
in ascending alpha-numeric sequence, cross-refer-
maintenance level. These assemblies will not be
stocked above DSU and GSU or returned to
enced to index number.
depot supply level.
Note. Source code is not shown on common
hardware items known to be readily available
The following provides an explanation of col-
in Army supply channels and through local
umns in the tabular lists in sections II, III, and
procurement.
(2) Maintenance code, indicates the lowest
IV:
category of maintenance authorized to install
a. Source, Maintenance and Recoverability
the listed item. The maintenance level code is:
Codes (SMR):
Code
Explanation
(1) Source code, indicates the selection sta-
O
Organizational maintenance
tus and source for the listed item. Source codes
(3) Recoverability code, indicates whether
are:
unserviceable items should be returned for re-
iii
