INTRODUCTION
Applied to repair parts which are not procured or
xl
stocked, the requirement for which will be supplied by
This manual lists repair parts required for the per-
use of the next higher assembly or components.
formance of organizational maintenance of the air
Applied to repair parts which are not stocked. The indi-
x2
cated maintenance category requiring such repair
parts will attempt to obtain them through cannibaliza-
tion; if not obtainable through cannibalization, such
repair parts will be requisitioned with supporting
a. The repair parts list is arranged as follows:
(1) Individual parts and major assemblies are
Applied to major assemblies that are procured with
G
listed alphabetically by item name within the num-
PEMA (Procurement Equipment Missile Army) funds
bered functional groups.
for initial issue only, to be used as exchange assem-
blies at DSU and GSU maintenance level. These
(2) Assembly components and subassemblies are
assemblies will not be stocked above DSU and GSU
indented and listed alphabetically by item name
level or returned to depot supply level.
under major assemblies.
Note. Source code is not shown on common hardware items
b. This repair parts and special tools list is divided
known to be readily available in Army supply channels and
into the following sections:
through local procurement.
(1) Prescribed Load Allowance (PLA) Section
(2) Maintenance code indicates the lowest cate-
II. A consolidated listing of repair parts quantitative-
gory of maintenance authorized to install the listed
ly allocated for initial stockage at the organizational
item. The maintenance level code is:
level. This is a mandatory stockage allowance.
Explanation
Code
(2) Special Tools, Test and Support Equipment
Organizational maintenance
O
Section III. A list of special tools, test and support
equipment authorized for the performance of main-
tenance at the organizational level. (Not applicable.)
(3) Recoverability code indicates whether un-
serviceable items should be returned for recovery or
salvage. Items not coded are expendable. Recover-
parts authorized for the performance of maintenance
at the organizational level.
ability codes are:
(4) Federal Stock Number and Reference Num-
ber Index -- Section V. A list of Federal stock num-
Code
bers followed by reference numbers in ascending
Applied to repair parts and assemblies which are econo-
R
alphanumeric sequence, cross-referenced to index
mically repairable at DSU and GSU activities and
number.
normally are furnished by supply on an exchange
basis.
3. Explanation of Columns
T
Applied to high dollar value recoverable repair parts
The following provides an explanation of columns in
which are subject to special handling and are issued
the tabular lists in sections II, III and IV:
on an exchange basis. Such repair parts normally
are repaired or overhauled at depot maintenance
a. Source, Maintenance, and Recoversability Codes
activities.
(SMR).
Applied to repair parts specifically selected for salvage
U
(1) Source code indicates the selection status and
by reclamation units because of precious metal con-
source for the listed item. Source codes used are:
tent, critical materials, high dollar value reusable
Explanation
casings or castings.
Code
P
Applied to repair parts which are stocked in or supplied
from DSA/GSA or Army supply system, and autho-
(4) This column also lists, below the SMR code,
rized for use at indicated maintenance categories.
an index number for each item in ascending numeri-
M
Applied to repair parts which are not procured or stocked
but are to be manufactured at indicated maintenance
cal sequence, which is used to locate items in the pub-
categories.
lication when the Federal stock number and/or refer-
Applied to assemblies which are not procured or stocked
A
ence number is known.
as such but made up of two or more units, each of
b. Federal Stock Number. This column indicates
which carry individual stock numbers and descriptions
the Federal stock number for the item.
and are procured and stocked and can be assembled
c. Description This column indicates the Federal
by units at indicated maintenance categories.
Applied to parts and assemblies which are not procured
x
item name and any additional description of the item
or stocked, the mortality of which is normally below
required. A part number or other reference number
that of the applicable end item, and the failure of
is followed by the applicable five-digit Federal
which should result in retirement of the end item from
supply code for manufacturers, in parentheses.
the supply system.