TM
5-4310-275-25P
INTRODUCTION
Note. Common hardware items known to be readily
1. Scope
available in Army supply channels are assigned mainte-
This manual lists repair parts, special tools, test
nance codes only. Source codes, recoverability codes, and
maintenance allowances are not assigned this category.
and support equipment required for the perform-
ance of organizational, direct support, general
(1) Source code. Indicates the selection
support, and depot maintenance of the com-
status and source for the listed item. Source codes
pressor.
used are:
Explanation
Code
2. General
Repair parts which are stocked in or supplied
P
This repair parts and special tools list is divided
from the GSA/DSA or Army supply system,
and authorized for use at indicated mainte-
into the following sections:
nance categories.
a. Prescribed Load Allowance (PLA)--Section
M
Repair parts which are not procured or stocked,
II. A composite listing of repair parts, special
but are to be manufactured at indicated
tools, test and support equipment having quanti-
maintenance levels.
tative allowances for initial stockage at the or-
Assemblies which are not procured or stocked
A
ganizational level.
as such, but are made up of two or more
units. Such component units carry individual
parts authorized for the performance of mainte-
stock numbers and descriptions, are procured
nance at the organizational level in figure and
and stocked separately and can be assembled
to form the required assembly at indicated
item number sequence.
maintenance categories.
c. Special Tools, Test and Support Equip-
Parts and assemblies which are not procured or
x
ment-Section IV. Not applicable.
stocked and the mortality of which normally
is below that of the applicable end item or
parts authorized for the performance of mainte-
component. The failure of such part or as-
sembly should result in retirement of the end
nance at the direct support, general support, and
item from the supply system.
depot level in figure and item number sequence.
Repair parts which are not procured or stocked.
X1
e. Special Took, Test and Support Equip-
The requirement for such items will be filled
ment--Section VI. Not applicable.
by use of the next higher assembly or com-
f. Federal Stock Number and Reference Num-
ponent.
ber Index--Section VII. A list of Federal stock
Repair parts which are not stocked, The indi-
X2
cated maintenance category requiring such
ascending numerical sequence,
numbers in
repair parts will attempt to obtain them
followed by a list of reference numbers appearing
through cannibalization. Where such repair
in all of the listings in alphanumeric sequence,
parts are not obtainable through cannibaliza-
cross-referenced to the illustration figure number
tion, requirements will be requisitioned, with
accompanying justification, through normal
and item number.
supply channels.
Note. Items not illustrated are cross-referenced to as-
Major assemblies that are procured with
G
sembly group number.
PEMA funds for initial issue only as ex-
change assemblies at DSU and GSU level.
The assemblies will not be stocked above GS
and DS level or returned to depot supply lev-
The following provides an explanation of columns
i n the tabular lists in sections II through VI:
(2) Maintenance code. Indicates the lowest
a. Source, Maintenance, and Recoverability
category of maintenance authorized to install the
Codes (SMR).
listed item. The maintenance codes are:
