TM 5-4310-335-14
(3) Remove elbow (10), nut (11), ring (12)
washers (11), machine screws (12), footman loop (13)
and packing (13).
and bracket (14).
(4) Remove nylon fitting (14), locknut (15)
(8) Remove locknuts (15), flatwashers (16),
and nylon tubing (16).
cushion clamp (17), flatwashers (18), machine screws
(5) Remove nuts (17), flatwashers (18),
(19), footman loop (20), pads (21) and bracket (22)
warning plate (19), saddle (20) and U-
securing sphere (23) to the frame and axle assembly.
bolt (21) freeing moisture separator (22)
from frame and axle assembly.
WARNING
(6) Remove tube (1, fig. 5-4), safety disc
Dry cleaning solvent, P-D-680, used
fitting (2), packing (3), tube tee (4),
to
clean
parts
is
potentially
hexagon nut (5), backup ring (6) and
dangerous
to
personnel
and
packing (7 and 8).
property. Do not use near open
(7) Remove strap (9), locknuts (10), flat-
flame or excessive heat. Flash point
of solvent is 100 138 (38 to
F
F
C
59 ).
C
b
Cleaning. Clean the moisture separator and
sphere with cleaning solvent, Fed. Spec P-D-
680, and dry thoroughly using filtered
compressed air.
c Inspection.
(1) Inspect metal parts for dents, scratches,
breaks, cracks, burrs, warpage, rough
edges or other damage.
(2) Inspect packing and tubing for cracks
and deterioration.
(3) Inspect tee, screws, and nuts for thread
damage.
(4) Inspect clamps washers, and straps for
corrosion, cuts or fraying.
(5) Inspect sphere mounting pads for dry
rot, splits or other damage.
(6) Repair any damage or replace parts
which obstruct moving parts or could
cause damage to the equipment.
d. Installation.
(1) Install locknuts (15, fig.
flatwashers (16), cushion clamp (17),
flatwashers (18), machine screws (19),
footman loop (20), pads (2i), and
bracket (22) securing sphere (23) to the
frame and axle assembly.
(2) Install strap (9), locknuts (10),
flatwashers (11), machine screws (12),
footman loop (13) and bracket (14).
(3) Install tube (1), safety disc fitting (2),
packing (3), tube tee (4), hexagon nut
(5), backup ring (6) and packing (7 and
8).
(4) Install nuts (17, fig. 5-3), flatwashers
(18), warning plate (19), saddle (20) and
U-bolt (21) securing moisture separator
(22) to frame and axle assembly.
(5) Install nylon fitting (14), locknut (15) and
Figure 5-3. Moisture Separator
nylon tubing. (16).
(6) Install elbow (10), nut (11), ring (12) and
packing (13).
5-12
