TM 5-4310-335-14
CHAPTER 6
REPAIR OF ROOF ASSEMBLY AND PNEUMATIC
SYSTEM ACCESSORIES
Section I. ROOF ASSEMBLY
6-1. Roof Assembly and Components
b. Disassembljy.
(1) Roof Assembly Compenents.
(b) Remove round head rivet (4), pop rivet washer (5) and instruction plate (6).
(c) Remove round head rivet (7), pop rivet washer (8) and schematic plate (9).
(d) Remove round head rivet (10), pop rivet washer (11) and instruction plate (12).
(e) Remove pads (13).
(f) Remove identification plates (14 through 22).
NOTE
Warning, instruction, data, or ID plates need not be removed unless damaged or
illegible.
(g)
Remove latches (23), locknuts (24), flatwashers (25 and 26) and screws (27) freeing door
(28).
(h) Remove locknuts (29), flatwashers (30), screws (31), and flatwashers (32) freeing hinge
(33).
flatwasher (38) and cushioned clamp (39).
(j) Remove locknut (40), flatwasher (41), binder head machine screw (42), flatwasher (43) and
cushioned clamp (44).
(k) Remove nipple (45), filter (46), nipple (47), tube(48), back pressure valve assembly (49),
preformed packing (50), check valve assembly (51), tube (52), and cross (53).
(l) Remove locknuts (54), flatwashers (55), fillister head machine screws (56) and flat- washers
(57).
(m) Remove locknuts (58), flatwashers (59), fillister head machine screws (60), flat- washers
(61), locknuts (62), flatwashers (63) binder head machine screws (64), flatwasher (65) and
tray brackets (66 and 67) freeing tray (68).
(n) Remove elbow fitting (69).
(o) Remove locknuts (70), flatwashers (71 and 72), hex head machine screws (73) and
flatwashers (74).
(p) Remove locknuts (75), flatwashers (76 and 77), hex head machine screws (78), flat-
washers (79) and tank straps (80) freeing fuel tank assembly (81).
(q) Remove tube clamps as necessary, tag and disconnect all air lines and fittings.
(r) Remove bulkhead elbow (82), hex bulkhead nut (83), backup ring (84), preformed packing
(85), bulkhead tee (86), hex bulkhead nut (87), backup ring (88), preformed packing (89),
bulkhead elbow (90), hex bulkhead nut (91), backup ring (92), preformed packing (93) and
regulator (94)
(98), hex head machine bolts (99), lock- washers (100), flatwashers (101) and regulator
brackets (102 and 103).
(t) Remove plug (104) and preformed packing (105).
(u) Remove bulkhead nut (106), washer (107 and 108), outlet fitting (109), adapter coupling
(110) and dust cap (111).
(v) Remove protector gage (112) and 0-600 gage (113).
(w) Remove locknut (114), washer (115), fillister head machine screws (116), washer (117) and
timer box assembly (118).
(x) Remove gage connector (119) and 0-4000 gage (120).
(y) Remove shut-off valve (121).
(z) Remove gage connector (122) and 0-5000 gage (123).
6-1
