INTRODUCTION
1. Scope.
The following provides an explanation of columns in
This manual lists repair parts, special tools, test
the tabular lists in Sections II through IV.
and support equipment required for the performance of
a. Source, Maintenance, and Recoverability Codes
organizational, direct support, general support, and
(SMR).
depot maintenance of the compressor.
(1) Source code. Indicates the selection status
and source for the listed item. Source codes used are:
2. General.
Code
Explanation
This Repair Parts and Special Tools List is divided
Repair parta which are stocked in or supplied
P
into the following sections:
from the GSA/DSA, or Army supply system and
authorised for use at indicated maintenance
a. Prescribed Load Allowance (PLA) - Section Il.
categories.
A. composite listing of repair parts, special tools, teat
Repair parts which are procured and stocked for
P2
and support equipment having quantitative allowances
insurance purposes because the combat or mili.
for initial stockage at the organizational level.
tary essentiality of the end item dictates that
a minimum quantity be available in the supply
item number sequence, of repair parts authorized at. the
system.
Repair parts which are not procured or stocked,
M
organizational level for the performance of maintenance,
but are to be manufactured at indicated main-
including those items which must be removed for re-
tenance levels.
placement of the authorized item. Items are listed by
Assemblies which are not procured or stocked
A
assembly group in top down breakdown sequence.
as such, but are made up of two or more units.'
c. Special Tools, Test and Support Equipment -
Such component units carry individual stock
numbers and descriptions, are procured and
Section IV. Not Applicable.
stocked separately and can be assembled to
form the required assembly at indicated mainten-
number sequence, of the repair parts authorized for the
ance categories.
performance of maintenance at the direct support, general
X
Parts and assemblies which are not procured or
stocked and the mortality of which normally is
support, and depot levels, including those items which
below that of the applicable end item or com-
must be removed for replacement of the authorized item.
ponent. The failure of such part or assembly
Items, except kits and sets, are listed by assembly
should result in retirement of the end item from
group in top down breakdown sequence. R e p a i r parts
the supply system.
kits and sets are listed separately as Group 07 at the
X1
Repair parts which are not procured or stocked.
The requirement of such items will be filled by
end of the Repair Parts List without regard to the as-
use of the next higher assembly or component.
sembly group to which they belong. Components of the
Repair parts which are not stocked. The indi-
X2
kits and sets are listed in their proper sequence in the
cated maintenance category requiring such
assembly group to which they belong and are referenced
repair parts will attempt to obtain them through
to the FSN of the kit or set.
cannibalization. Where such repair parts are
not obtainable through cannibalization, require-
e. Special TO OI S , Test and Support Equipment -
ments will be requisitioned, with accompanying
Section VI. Not Applicable.
justification , through normal supply channels.
f. Federal Stock Number and Reference Number
Major assemblies that are procured with PEMA
G
funds for initial issue only as exchange assem-
in ascending numerical sequence, followed by a list of
blies at DSU and GSU level. These assemblies
will not be stocked above GS and DS level or
reference numbers appearing in all listings, in ascend-
returned to depot supply level.
ing alpha-numeric s e q u e n c e, cross-referenced to the
illustration figure and item number.
( 2 ) Maintenance code. Indicates the lowest
Note Items not illustraded are cross-referenced to page
category of maintenance authorized to install the
number.
listed item. The maintenance codes are:
