TM 5-4310-347-24P
SECTION I.
INTRODUCTION
1. Scope
3. Explanation of Columns
The following provides an explanation of columns found
in the tabular listings in sections III through VI
a. This manual 1lists repair parts, special tools, test
a. Source, Maintenance, and Recoverability Codes
and support equipment required for the performance of
(SMR).
organizational, direct support, general support, and depot
(1) Source code indicates the source for the listed
maintenance of the compressor.
items. :Source codes are:
. Repair parts 'listed represent those authorized for
use at indicated maintenance levels and ill be
Code
Explanation
requisitioned on an "as required" basis until stockage is
P
Repair Parts, Special Tools and Test Equipment
justified by demand in accordance with AR 7.10-2.
supplied from the GSA/DSA or Army supply
system, and authorized for use at indicated
2. General
maintenance levels.
P2
Repair Parts, 'Special Tools and Test Equipment
This Repair Parts and Special Tools List is divided into
which are procured and stocked for insurance
the following sections:
purposes because the combat or military
. Prescribed Load Allowance List-Section II Not
essentiality of the end item dictates that a
Applicable).
minimum quantity be available in the supply
. Repair Parts List-Section III A list of repair parts
system.
authorized at the organizational level or the performance
P9
Assigned to items which are NSA design
of maintenance. The list also includes parts which must
controlled: unique repair parts, special tools,
be -removed for replacement of the authorized parts.
test, measuring, and diagnostic equipment which
Parts lists are composed of assembly groups in
are stocked and supplied by the Army COMSEC
ascending numerical sequence, with the parts in each
Logistic System and which are not subject to the
group 'listed in figure and item number sequence.
provisions of AR 380-41.
c. Special Tools, Test and Support Equipment-
P10
Assigned to items which are NSA design
Section IV (Not Applicable).
controlled: special tools, test, measuring, and
d. Repair Parts List-Section V A list of repair parts
diagnostic equipment for COMSEC support
authorized at the .direct support, general support, and
which are accountable under the provisions of
depot levels for the performance of maintenance. The list
AR 380-41 and which are stocked and supplied
also includes parts which must be removed for the
by the Army COMSEC Logistic System.
replacement of the authorized parts. Parts list are
M
Repair Parts, Special Tools and Test Equipment
composed of assembly groups in ascending numerical
which are not procured or stocked as such in the
sequence, with parts in each group listed in figure and
supply system but are to be manufactured at
item number sequence.
indicated maintenance levels.
e. Special Tools, Test and Support Equipment-
A
Assemblies which are not procured or stocked
Section VI (Not Applicable).
as such, but are made up of two or more units.
f. Federal Stock Number and Reference Number
Such component units carry individual stock
Index-Section VII A list, in ascending numerical
numbers and descriptions, are procured and
sequence, of all Federal stock numbers appearing in the
stocked separately, and can be assembled to
'listings, followed by a list, in alpha-numeric sequence, of
form the required assembly at indicated
al1 reference numbers appearing in the listings. Federal
maintenance categories.
stock number and reference numbers are cross-
X
Parts and assemblies that are not procured or
referenced to each illustration figure and/or item number
stocked because the failure rate is normally
appearance.
below that of the applicable end item or
component.
iii
