TM 5-4310-347-24P
special tools for DS/IGS levels of maintenance will
5. 'How to Locate Repair Parts
represent initial stockage for a 30Sday period for the
a. When Federal stock number or reference number
number of equipments supported. (Not Applicable).
is unknown:
h. One-Year Allowances Per 100 Equipment/
(1) First. Using the table of contents determine the
Contingency Planning Purposes.
assembly group with-in which the repair part belongs.
(1) Items authorized for use as required but not for
This is necessary since illustrations are prepared for
initial stockage are identified with an asterisk in the
assembly groups, and listings -are divided into the same
allowance column.
groups.
(2) This column indicates the total quantity of special
(2) Second. Find 'the illustration covering the
tools .required for distribution and contingency planning
assembly group to which the repair part belongs.
purposes. (Not Applicable).
(3) Third. Identify the repair part on the illustration
i. Depot Maintenance Allowance Per 100 Equipment.
and note the illustration figure and item number of the
(1) Items authorized for use as required but not for
repair part.
initial stockage are identified with an asterisk in the
(4) Fourth. Using the Repair Parts Listing, find the
allowance column.
assembly group to which the repair part 'belongs and
(2) This column indicates the total quantity of special
locate the illustration figure and -item number noted on
tools authorized for depot maintenance of ,100
the illustration.
equipments. (Not Applicable).
b. When the Federal stock number or reference
j. Illustration. This column is divided as follows:
number is known:
(1) Figure number. Indicates the figure number of
(1) First. Using the Index of Federal Stock Numbers
the illustration on which the item is shown.
and Reference Numbers find the pertinent Federal stock
(2) Item number. Indicates the callout number used
number or reference number. This index is in ascending
to ,reference the item on the illustration.
FSN sequence followed by a list of -reference numbers
in alpha-numeric sequence, crass-referenced to the
4. Special Information
illustration figure number and item number.
a. The basis of issue for authorized special tools,
(2) Second. Using the Repair Parts Listing, find the
test and support equipment is the number of end items
assembly group of the repair part and the illustration
of equipment ,supported and the number of maintenance
figure number and item number referenced in the Index
personnel allocated to perform the required maintenance
of Federal Stock Numbers and Reference Numbers.
operations.
b. Parts which require manufacture or assembly of a
6. Recommendations for Maintenance Publications
maintenance level higher than that authorized for
Improvements
installation will indicate in the source column the higher
You can improve this manual by calling attention to
maintenance level.
errors and by recommending improvements, using DA
c. Repair parts kilts and gasket sets appear as the
Form 2028 (Recommended Changes ,to Publications)
last entries 'in the repair parts listing for the group or
or by a letter, and mailing directly to Commanding
assembly to which they apply.
General, U.S. Army Mobility Equipment Command,
d. The following publication pertains to the
ATTTN: AMSME-MPP, 4300 Goodfellow 'Boulevard, St.
compressor and its components:
Louis, Mo. '63120. A -reply will be furnished directly to
TM 5-4310-347-14 Operator,
Organizational
Direct
you.
Support and General Support
Maintenance Manual
V
