TM 5-4310-350-24P
ORGANIZATIONAL, DIRECT AND GENERAL SUPPORT MAINTENANCE
REPAIR PARTS AND SPECIAL TOOLS LIST
Scope.
1.
This manual lists spares and repair parts; special tools; special
test, measurement, and diagnostic-equipment (TMDE) , and other special
support equipment required for performance of organizational, direct
support, general support maintenance of the air compressor. It auth-
orizes the requisitioning and issue of repair parts as indicated by
the source and maintenance codes.
2.
General.
This Repair Parts and Special Tools List is divided into the
following sections:
a. Section II. Repair Parts List. A list of spares and repair
parts authorized for use in the performance of maintenance. The list
also includes parts which must be removed for replacement of the auth-
orized parts. Parts lists are composed of functional groups in numer-
ic sequence, with the parts in each group listed in figure and item
number sequence. Bulk materials are listed in NSN sequence.
b. Section III. Special Tools List. A list of special tools,
special TMDE, and other special support equipment authorized for the
performance of maintenance (not applicable).
c. Section IV. National Stock Number and Part Number Index. A
list, in National item identification number (NIIN) sequence, of all
National stock numbers (NSN) appearing in the listings, followed by a
list in alphameric sequence of all part numbers appearing in the list-
ings. National stock numbers and part numbers are cross-referenced
to each illustration figure and item number appearance. This index
is followed by a cross-reference list of reference designators to
figure and item numbers.
Explanation of Columns.
3.
This column is divided as follows:
a.
Illustration.
(1) Figure Number. Indicates the figure number of the
illustration on which the item is shown.
The number used to identify item called out
(2) Item Number.
in the illustration.
Source, Maintenance, and Recoverability (SMR) Codes.
b.
(1) Source Code. Source codes indicate the manner of acquiring
support items for maintenance, repair, or overhaul of end items.
Source codes are entered in the first and second positions of the
Uniform SMR Code format as follows:
1
