TM 5-4310-352-14
(8) Energize power source.
(2) Refer to figure 6-9, break the outlet air line
at union, then remove air line components back to the
out- let air filter.
6-8. Air Receiver Replacement
(3) Tag and disconnect electrical leads to
a. General. When a defective receiver must be
junction box of heater.
replaced, follow a procedure similar to that described be-
low, after disconnecting all power.
NOTE
b. Removal.
The filter bowl may require removal from head
(1) Remove the motor (para 4-9).
before the head can be unscrewed from the air
(2) Remove the air compressor (para 4-10).
line.
(3) Remove the motor starter (para 6-3).
(4) Remove the pressure switch (para 6-4).
(4) Remove the outlet air filter from the air
(5) Remove dehydrator with bracket (para
line.
(5) Install air filter to air line.
(6) Disconnect and remove all external piping
(6) Connect electrical leads to heater junction
and components of the outlet airline, brackets and cast-
box.
ers.
(7) Connect air line components from air filter
to union.
6-14
