TM 5-4310-354-14
APPENDIX B
COMPONENTS OF END ITEMS LIST
Section I. INTRODUCTION
B-1. Scope. This appendix lists Integral Components of
b. National Stock Number (NSN): Indicates the
and Basic Issue Items (BII) for the air compressor to
national stock number assigned to the end item which
help you inventory items required for safe and efficient
will be used for requisitioning.
operation.
c. Part Number (PIN):
Indicates the primary
B-2. General. The components of end item list are
number used by the manufacturer which controls the
divided into the following sections:
design and characteristics of the item by means of its
engineering drawings, specifications, standards and
inspection requirements to identify an item or range of
These items, when assembled, comprise the air
items.
compressor and must accompany it whenever it is
transferred or turned in. These illustrations will help you
d. Description: Indicates the federal item name
identify these items.
and, if required, a minimum description to identify the
item.
minimum essential items required to place the air
e. Location: The physical location of each item
compressor in operation, to operate it and to perform
listed is given in this column. The lists are designed to
emergency repairs.
Although shipped separately
inventory all items in one area of the major item before
packed, they must accompany the air compressor during
moving on to an adjacent area.
operation and whenever it is transferred between
accountable officers. The illustrations will assist you with
f. Usable on Code: "USABLE ON" codes are
hard-to-identify items. This manual is your authority to
included to help you identify which component items are
requisition replacement BII based on Table(s) or
used on the different models. Identification of the codes
Organization and Equipment (TOE)/Modification Table of
used in this list are:
Organization and Equipment (MTOE) authorization of
the end item.
CODE
USED ON
g. Quantity Required (Qty Reqd): This column lists
B-3. Explanation of Columns.
the quantity of each item required for a complete major
a. Illustration: This column is divided as follows:
item.
(1) Figure Number:
Indicates the figure
h. Quantity:
This column is left blank for use
number of the illustration on which the item is shown (if
during inventory. Under the received column, list the
applicable).
quantity you actually receive on your major item. The
date columns are for use when you inventory the major
(2) Item Number:
The number used to
item at a later date, such as for shipment to another site.
identify item called out in the illustration.
B-1
