TM 5-4310-358-14
1. Gasket, valve
2. Screw, machine
3. Cage, exhaust
4. Spring, valve
5. Disc, valve
6. Seat, exhaust
7. Gasket, valve
8. Gasket, valve
9. Screw, machine
10. Seat, intake
11. Disc, valve
12. Spring, valve
13. Cage, intake
14. Gasket, valve
15. Gasket valve
16. Screw, machine
17. Cage, exhaust
18. Spring, valve
19. Disc, valve
20. Seat, exhaust
21. Gasket, valve
22. Screw, machine
23. Lockwasher
24. Seat, intake
25. Disc, valve
26. Spring, valve
27. Cage, intake
28. Gasket, valve
Figure 5-8. Compressor valve assemblies, disassembly and reassembly.
b. Cleaning, Inspection and Repair.
and 18) by removing piston pin retaining rings (11) and
(1) Clean all parts with an approved cleaning
piston pins (12 and 17).
solvent and dry thoroughly.
(2) Inspect the cylinder block for broken
NOTE
cooling fins and cracks. Inspect the cylinder bore for
wear, scoring, pitting or other damage. Replace the
Do not remove piston pin bearings
block if defective. Refer to Table 5-2 for allowable wear
(14) from rods unless replacement is
tolerances.
required.
5-17
