TM 5-4310-360-14
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I.
INTRODUCTION
b. National Stock Number. Indicates the
B-1. Scope.
National stock number assigned to the item and
This appendix lists integral components of and
which will be used for requisitioning.
c. Part Number. Indicates the primary number
help you inventory items required for safe and
used by the manufacturer, which controls the
efficient operation.
design and characteristics of the item by means of
its engineering drawings, specifications, standards,
B-2. General.
and inspection requirements to identify an item or
The components of end item list are divided into
range of items.
the following sections:
d. Description. Indicates the Federal item
a. Section II, Integral Components of the End
name and, if required, a minimum description to
Item. These items, when assembled. comprise the
identify the item.
e. Location. The
physical location of each item
is transferred or turned in. The illustrations will
listed is given in this
column. The lists are designed
help you identify these items.
to inventory all items
in one area of the major item
b. Section III. Basic Issue Items These are
before moving on to
an adjacent area.
minimum essential items required to place the Air
on Code. "USABLE ON" codes are
f. Usable
Compressor in operation, to operate it, and to
included to
help you identify which component
perform emergency repairs. Although shipped
items are
used on the different models.
separately packed they must accompany the
Identification
of the codes used in these lists are:
Compressor during operation and whenever it is
transferred between accountable officers The
Used On
Code
illustrations will assist you with hard-to identify
items. This manual is your authority to requisition
Model 20-902/3
MAA
replacement BII, based on TOE/MTOE
authorization of the end item.
g. Quantity Required (Qty Reqd). This
column lists the quantity of each item required for a
B-3. Explanation of Columns.
complete major item.
a. Illustration. This column is divided as
h. Quantity. This column is left blank for use
follows:
during an inventory. Under the Rev'd column, list
the quantity you actually receive on your major
(1) Figure Number. Indicates the figure
item. The Date columns are for your use when you
number of the illustration on which the item is
inventory the major item at a later date, such as for
shown.
shipment to another site.
(2) Item Number. The number used to
identify item called out in the illustration.
B-1