TM 5-4310-368-14
s.
Unscrew one internal hex-head screw (25), remove lock washer (26), two hex nuts (24) and two washers (23).
t.
Remove two internal hex-head screws (22), two washers (23), and finned tube support (21) from upper
crankcase.
6-50.
a.
Loosen two hose clamps (17), pull out vent hose (18) from intake connection of 1st stage and from demister
top (20).
b.
Unscrew plug (15) and remove O-ring (16).
c.
Remove retaining clip (19) and demister top (20) with gasket (21) from demister body (22).
d.
Unscrew demister body (22) with gasket (23) from extension (24).
e.
Unscrew extension (24) from crankcase (37).
6-51.
a.
Unscrew four internal hex-head screws (2).
b.
Remove washers (3) and V-belt guard (1).
6-52.
a.
Accomplish necessary prerequisites (see Figure 6-44).
b.
Unscrew three internal hex-head screws (18) on lower V-belt pulley and remove lock washers (20).
c.
Unscrew two internal hex-head screws (19) and remove two lock washers (20).
d.
Remove V-belt pulley part (17), spacers (21) and V-belt (7).
e.
Remove V-belt pulley part (22) from eccentric shaft (30).
f.
Unscrew two internal hex-head screws (5) from upper V-belt pulley part (4) and remove two lock washers (6).
g.
Remove V-belt pulley (4) from crankshaft and remove key (29) from key slot.
6-53
a.
Accomplish necessary prerequisites (see Figure 6-44).
b.
Unscrew three internal hex-head screws (14) and remove washers (15).
c.
Remove oil pump (13) from crankcase and remove gasket (18).
6-54
