TM 5-4310-370-14
the total dimension found above. Proper adherence to this procedure will minimize crankshaft end play. For
d. Put new gasket and shim set into place, reassemble and torque four hex cap screws (figure 5-10, item 1) to 125
in. lbs. (22,325 gr. cm.).
5-8. CYLINDER, PISTON ASSEMBLIES, AND CONNECTING ROD ASSEMBLIES REASSEMBLY.
a. Piston and Rod Assemblies Reassembly
(1) Replace oil scoop and pin (figure 5-9, items 16 and 17) into position and cover with oil scoop retainer (figure
(2) Reassemble connecting rod assemblies (figure 5-9, item 13) by use of six connecting rod hex cap screws
(figure 5-9, item 14). Torque six hex cap screws to
125 in. lbs. (22,325 gr. cm.).
tighten six hex cap screws.
(7) Fill compressor with oil, being sure not to over fill. Replace oil fill plug (figur e 5-9, item 7).
b. Cylinder Reassembly
(1) Low Pressure Cylinder Reassembly
hex cap screws (figure 5-8, item 2) down to 144 in. lbs. (25,718 gr. cm.).
(2) High Pressure Cylinder Reassembly
hex cap screws (figure 5-8, item 2) down to 144 in. lbs. (25,718 gr. cm.).
5-24