TM 5-4310-370-14
5-9. INTERCOOLER TUBE ASSEMBLY AND HEAD ASSEMBLIES REASSEMBLY.
a. Low Pressure Heads
(1) Reassemble parts in the following sequence into both reed valve heads (figure 5-7, item 3).
(2) Valve plate gasket (figure 5-7, item 4)
(3) Reed valve (figure 5-7, item 7)
(4) Rolling screw (figure 5-7, item 6)
(5) Valve plate (figure 5-7, item 5)
(6) Filter silencer (figure 5-7, item 2)
(7) Filter (figure 5-7, item 1)
(8) Low pressure retainer (figure 5-7, item 8)
b. High Pressure Head
(1) Reassemble parts in the following sequence into cylinder head (figure 5-6, item 7).
(2) Two valve gaskets (figure 5-6, item 5)
(3) Exhaust valve (figure 5-7, item 6)
(4) Intake valve (figure 5-6, item 4)
(5) Two valve retainers (figure 5-6, item 3)
(6) Two valve chamber cap gaskets (figure 5-6, item 2)
(7) Two valve chamber caps (figure 5-6, item 1)
c. Head Assemblies
(1) Replace low pressure head gasket (figure 5-5, item 6).
(2) Install both low pressure head assemblies (figure 5-5, item 4) by turning eight hex cap screws (figure 5-5,
item 5) counter clockwise.
(3) Replace high pressure head gasket (figure 5-5, item 3).
(4) Install high pressure head assembly (figure 5-5, item 1). Install and torque four hex cap screws (figure 5-5,
item 2) to 144 in. lbs. (25,718 gr. cm.).
d. Intercooler Tube Assembly
(1) Replace all compression fittings (figure 5-4, item 7).
5-25
