TM 5-4310-371-14
NOTE
The following steps must be performed by a utilities repairer:
a. Remove junction box acorn nuts by turning them counter clockwise and remove junction box cover and junction
box gasket. (Figure 4-2)
b. Disconnect starter switch and motor leads by removing tape, screws and nuts from wire lugs. (Figure 4-3)
c. Disconnect motor cable from junction box by removing cable connection nuts as shown in figure 4-3.
d. Install motor cable to junction box and replace cable connection nut.
e. Install starter switch and motor leads by replacing screws and nuts through wire lugs and tightening, then taping
wire lugs (Figure 4-3).
f. Install junction box gasket, junction box cover, and replace junction box acorn nuts by turning them clockwise.
TM 5-4310-371-14/4-3
FIGURE 4-3. STARTER SWITCH-MOTOR DISCONNECT
4-9
