TM 5-4310-375-14
Table 5-1. Direct Support and General Support Troubleshooting- Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Refer to para 5-6.a and adjust pressure switch.
Step 2. Check for incorrect lead connections in pressure switch.
Step 3. Check for a defective pressure switch.
Refer to para 5-6.b and repair or replace defective pressure switch.
6. COMPRESSOR NOT PRODUCING ENOUGH COMPRESSED AIR OR PRODUCING TOO SLOWLY.
When advised by organizational maintenance of malfunction of air compressor beyond repair capability of their
level, the air compressor shall be repaired/overhauled.
Refer to para 5-7 for air compressor repair/overhaul.
7. INTERCOOLER AND AFTERCOOLER.
When advised by organizational maintenance of malfunction of intercooler and aftercooler beyond repair
capability of their level, the intercooler or aftercooler shall be replaced.
Refer to para 5-8.
8. AIR RECEIVER TANK.
When advised by organizational maintenance of malfunction of air receiver tank beyond repair capability at
their level, the air receiver tank shall be replaced.
Refer to para 5-11.
Section II. MAINTENANCE PROCEDURES
5-3.
Introduction. This section explains maintenance procedures which are the responsibility of the direct support
and general support maintenance technicians as authorized by the MAC (Appendix B) and the Source, Maintenance, and
Recoverability (SMR) coded items.
Maintenance procedures. Maintenance procedures are presented in the same order, as applicable, listed in para
5-4.
graph 4-13. Complete instructions for maintenance operations within the scope of this maintenance level for each
Functional Group is provided in step-by-step procedures in following paragraphs.
Electric motor assembly. Maintenance of the electric motor assembly is as follows:
5-5.
5-3
