--
5-4310-378-14
1-10. IDENTIFICATION
The compressor has two identification plates, as follows:
A.
Operating Procedure Plate. The operating procedure plate is located on the fuel
tank.
WEATHER
OPERATING PROCEDURES
1
CHECK ENGINE OIL LEVEL
1
2
CHECK COMPRESSOR OIL LEVEL
W I T H FUEL
FE OSTOVVG 76
3.
CHECK FUEL LEVEL
CLASS B
4.
DRAIN ENGINE OIL
2
TURN FUEL TANK VALVE ON
WITH
OIL
MI
5
OPEN FUEL TANK VENT VALVE
6
PULL ENGINE CUTOFF SWITCH TO
3
OR AI N COMPRESSOR OIL AND SERVICE
THE OUT POSITION.
WITH ARCTIC OIL
7.
PLACE CHOKE TO ON POSITION
4
FOLLOW ST
NORMAL
8.
RELEASE BELT TENSION
OPERATING PROCEDURES
9
PULL STARTING ROPE SHARPLY
IF ENGINE FAIL ST OS TART SEE
5
UNTIL ENGINE STARTS
ALLOW ENGINE TO WARM THEN
10
MOVE CHOKE TO OFF
11.
sLOWLY ENGAGE
1
12
MOVE THROTTLE TO IDLE
MOVE THROTTLE TO MAX POSITION
Stop
PUSH ENGINE CUTOFF SWITCH
TO THE IN POSITION
FU E L T AN K VE N T V A L V E
TURN FUEL TAN KVALVE OFF
4.
1.
MOVE THROTTLE TO IOLE
2.
PUSH ENGINE CUTOFF
TO THE IN POSITION
3.
CLOSE FUEL TANK VENT VALVE
4.
T U R N F U E L T A N K VA L VE O F F
B.
Identification Plate. Theidentification plate islocatedon the left frame rail near
the handle. It provides the compressor nomenclature, national stock number, compressor and
engine serial numbers, contract number, weight, and dimension.
--
r
PORTABLE
AIR
COMPRESSOR
175 PSI
o
o
58328
]
WARRANTY
CONTR
NO.
1
DATE
DATE
INSP
"R
`GAL
NET W T
LG
0
"G
`
DATE
MFD
HGT
NSN
4310-01.0285
MFD
ENERGY
RESEARCH
0
--.
PROPERTY
------..
.
1-4
Change
