Governor Assembly - TM-5-4310-379-14

Figure 4-7. Governor, Adjust (Sheet 1 of 2).

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
231

TM 5-4310-379-14 4-11. Governor Assembly This task covers: a. Adjust b. Replace INITIAL SETUP Tools Equipment Condition General Mechanic's Tool Kit Breather pipe removed (para. 3-40). (NSN 5180-00-177-7033) Rocker cover removed (para. 3-39). Oil filter removed (para. 3-37). Materials/Parts Governor Gasket, Governor Mounting Gasket, Governor to Cylinder Head Mounting a. Adjust. (figure 4-7) (1) Loosen screw (1). (2) Loosen two screws (2) and remove throttle cable (3). (3) Loosen screw (4). (4) Loosen two screws (5) and remove stop cable (6). (5) Remove four screws (7), lockwashers (8), spacer (9) and remove cover (10) and bracket (11). (6) Hold speed control lever (12) in maximum speed position. (7) Measure gap between plunger guide (13) and spring plunger (14). Gap should be 0.0096 in. Gauge (0.01524 cm). Loosen nut (15) and adjust screw (16) until proper gap is achieved and tighten nut (15). (8) Install cover (10) and bracket (11) and secure with four screws (7), lockwashers (8), and spacer (9). (9) Install stop cable (6) and tighten two screws (5) and screw (4). (10) Install throttle cable (3) and tighten two screws (2) and screw (1). Change 1 4-18

Privacy Statement
Press Release
Contact