TM 5-4310-379-14
4-11.
Governor Assembly (Cont).
b.
Replace. (figure 4-8)
(1) Remove cotter pin (1) and remove pin (2).
(2) Loosen screw (3).
(3) Remove two screws (5), lockwashers (4), and block (6) and remove cable (7) from governor assembly (8).
(4) Loosen screw (9).
(5) Remove two screws (10), lockwashers (11) and block (12) and remove cable (13) from governor assembly
(8).
(6) Remove two screws (14) and lockwashers (15) securing governor assembly (8) to cylinder block (16).
(7) Remove four screws (17) and lockwashers (18) and remove governor assembly (8) and gaskets (19) and
(20).
(8) Ensure gasket surfaces are clean and old gasket material is removed.
(9) Install governor assembly (8) and gaskets (19) and (20) and secure with four screws (14) and lockwashers
(15).
(10) Install two screws (14) and lockwashers (15).
(11) Install cable (13) and secure with two screws (10), lockwashers (11), and block (12) and tighten screw (9).
(12) Install cable (7) and secure with two screws (5), lockwashers (4), and block (6) and tighten screw (3).
(13) Position rod (21) in control rack and secure with pin (2) and cotter pin (1).
(14) Adjust governor assembly.
FOLLOW-ON MAINTENANCE:
Install oil filter (para. 3-37).
Install rocker cover (para. 3-39).
Install breather pipe (para. 3-40).
Change 1
4-22
