TM 5-4310-379-14
2-8.
Reporting Deficiencies. If your equipment does not perform as required, refer to Chapter 3 under
Troubleshooting for possible problems. Report any malfunctions or failures on DA Form 2404, or refer to DA Pam 738-
750.
2-9.
Equipment Is Not Ready/Available If Column. This column lists conditions that make the equipment
unavailable for use because it is unable to perform its mission, or because it would represent a safety hazard. Do not
accept or operate equipment with a condition in the "Equipment is Not Ready If" column.
NOTE
The terms ready/available and mission capable refer to the same status:
Equipment is on hand and is able to perform its combat mission. Refer to DA
Pam 738-750.
2-10.
Special Instructions. Preventive maintenance is not limited to performing the checks and services listed in the
PMCS table.
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to
personnel and property. Avoid repeated and prolonged skin contact. Do not use
near open flame or excessive heat. Flash point of solvent is 100 138°F (38 60°C).
a. Keep it clean. Dirt, grease, oil, and debris get in the way and may cover up a serious problem. Clean as you
work and as needed. Use dry cleaning solvent on all metal surfaces. Use soap and water to clean rubber or plastic
material.
b. Bolts. Nuts. and Screws. Check them all for obvious looseness, missing, bent, or broken condition. You can't
try them all with a tool, but look for chipped paint, bare metal, or rust around boltheads. If you find one you think is loose,
tighten it, or report it to unit maintenance if you can't tighten it.
c. Electrical Wires and Cable Connectors. Look for bare wires, and loose or broken connectors. Report defects to
unit maintenance.
d. Fluid Lines. Look for wear,. damage, and leaks. Make sure clamps and fittings are tight. Wet spots and stains
around a fitting or connector can mean a leak. If a leak comes from a loose connector, tighten It. If something is broken
or worn out, report it to unit maintenance.
e. Leakage Definitions. It is necessary for you to know how fluid leakage affects the status of your equipment. The
following are definitions of the types/classes of leakage you need to know to be able to determine the status of your
equipment. Learn and be familiar with them. When in doubt, NOTIFY YOUR SUPERVISORI
Leakage Definitions:
Class I
Seepage of fluid (as indicated by wetness or discoloration) not great
enough to form drops
Class II
Leakage of fluid great enough to form drops but not enough to cause
drops to drip from item being checked/inspected.
2-6
