TM 5-4310-382-13
3-27. GOVERNOR LINKAGE AND THROTTLE LINKAGE.
This task covers:
a. Removal
b. Cleaning
c. Inspection
d. Installation
e. Adjustment
INITIAL SETUP
Tools Required
Tool Kit, General Mechanic's
Materials Required
Brush, Medium Bristle (item 4, Appendix E)
Solvent, Dry Cleaning (item 2, Appendix E)
Cloth, Lint-Free (item 3, Appendix E)
Equipment Condition
Engine shut down and cool.
a. Removal.
(1) Remove screw (9), screw (18), nut (16), and lockwasher (17) from slow down device (8) and disconnect slow
down device link from governor control plate (11).
(2) Remove spring (6) from lever assembly (3) and governor control plate (11).
(3) Remove screw (7), screw (10), and governor control plate (11).
(4) Remove screw (4), nut (5), lever (3), and washer (19) from governor shaft (15).
(5) Remove link (2) from lever assembly (3) and throttle shaft (1) on carburetor.
(6) Remove nut (12) and washer (13) from insulator (14).
(7) Remove insulator (14) from governor control plate (11) by pressing tabs (20) with a screwdriver and pulling
insulator straight out.
3-56
