TM 5-4310-382-13
4-3. CARBURETOR - Continued.
d. Assembly.
NOTE
Replace all gaskets with new gaskets during assembly.
(1) Install nozzle (9) into lower carburetor (5).
(2) Place gasket (4) and lower carburetor (5) into position on upper carburetor (3). Be sure nozzle tip enters
upper carburetor (3).
(3) Install four screws (1) into upper carburetor (4).
(4) Install high speed gasket (8) and needle valve (7) into lower carburetor (5), but do not tighten packing nut (6).
(5) Screw in high speed needle valve screw (7) until it just seats into nozzle (9) and then back off high speed
needle valve 1 1/2 turns.
(6) install idle speed needle valve (2) into upper carburetor (3).
(7) Screw in idle speed needle valve (2) until it just seats into upper carburetor (3) and then back screw off 3/4
turn.
Figure 4-2. Carburetor, Assembly.
4-6
