TM 5-4310-384-13
3-24.
V-BELT. This task covers:
a.
Removal.
b.
Installation.
e.
Adjustment.
INITIAL SETUP.
a.
Tools. General Automatic Tool Set, T1 5180-00-177-7033.
b.
Equipment Condition. Main power disconnected; Compressor unit OFF; Belt guard cover removed (paragraph 3-
23).
c.
General Safety Requirements.
WARNING
Observe all Warnings and Cautions.
Never wear loose clothing or jewelry while inspecting or servicing equipment.
Beware of rotating shafts, pulleys and fans which could entrap personnel and cause serious injury.
V-Belt
REMOVAL
WARNING
Disconnect main power source and turn compressor unit off before performing maintenance procedures.
a.
Disconnect the main power source and turn compressor switch OFF.
b.
Loosen the electric motor mounting bolts (1) and slide motor towards compressor flywheel to relieve belt tension.
CAUTION
Belts may be cut or damaged if removed under tension.
c.
Remove two V-belts (2).
3-28
