TM 5-4310-385-13
3-25. DRIVE PULLEY. This task covers:
a. Initial Setup.
b. Removal.
c. Installation.
d. Alignment.
INITIAL SETUP.
a.
Tools. General Mechanic Automotive Tool Set T1 5180-00-177-7033. Automotive Maintenance and Repair Shop
Equipment T3 4910-00-754-0654.
b.
Equipment Condition. Main power disconnected; Compressor unit OFF; Belt Guard Remove (paragraph 3-23) ;
V-Belts Removed (paragraph 3-24).
c.
General Safety Requirements.
WARNING
·
Observe all Warnings and Cautions.
·
Never wear loose Clothing or jewelry while inspecting or servicing equipment.
·
Beware of rotating shafts, pulleys and fans which could entrap personnel and
cause serious injury.
REMOVAL.
WARNING
Disconnect main power source and turn compressor unit off before performing
maintenance procedures.
a.
Disconnect the main power supply and turn the power switch OFF.
b.
Remove the belt guard. Refer to paragraph 3-23.
c.
Remove the V-belts. Refer to paragraph 3-24.
3-24