TM 5-4310-385-13
REMOVAL.
WARNING
Disconnect main power source and turn compressor unit OFF before performing
maintenance procedures.
a.
Disconnect the main power and turn the power switch OFF.
b.
Remove the screws (1) that retain the belt guard (2) to the base plate (3).
c. If base plate (3) must be removed, refer to paragraph 3-25 for drive pulley(4) removal and paragraph 3-30 for
flywheel (5) removal.
d.
Remove the mounting bolts, nuts, and lockwashers (6) securing base plate (3) to tank saddle (7).
e.
Remove the base plate (3).
REPAIR.
a.
Inspect the belt guard for missing rivnuts (8). Replace with metal screws as necessary.
b.
Inspect the belt guard (2) and base plate (3) for damage. Straighten as necessary to ensure correct fit and
alignment.
INSTALLATION.
a.
Disconnect the main power and turn the power switch OFF.
b.
Install the base plate (3) and mounting hardware (6) if removed.
c.
Refer to paragraph 3-25 for drive pulley (4) installation and paragraph 3-30 for flywheel (5) installation.
d.
Install belt guard (2) and retaining screws (1).
e.
Reconnect the main power source and turn compressor on.
3-21