TM 5-4310-386-14
4-34. Injector Lines.
This task covers: Replace
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tool Kit
Compressor unit shut down (para. 2-13).
(NSN 5180-00-177-7033)
Materials/Parts
Injector Lines
Replace. (figure 4-42)
(1)
Loosen fitting nut (1) and remove line (2) from injector pump (3).
(2)
Remove bolt (4), two washers (5), rubber sleeve (6), and pipe clip (7).
(3)
Loosen fitting nut (8) and remove line (2).
(4)
Loosen fitting nut (9) and remove line (10) from injector pump (3).
(5)
Remove bolt (11), two washers (12), rubber sleeve (13), and pipe clip (14).
(6)
Remove nut (15), washer (16), bolt (17), pipe clip (18), and rubber sleeve (19) from end plate (20).
(7)
Loosen fitting nut (21) and remove line (10).
(8)
Install line (10) and tighten fitting nut (21).
(9)
Install rubber sleeve (19), pipe clip (18), bolt (17), washer (16), and nut (15).
(10)
Install pipe clip (14), rubber sleeve (13), two washers (12), and bolt (11).
(11)
Install line (10) on injector pump (3) and tighten fitting nut (9).
(12)
Install line (2) and tighten fitting nut (8).
(13)
Install pipe clip (7), rubber sleeve (6), two washer (5)', and bolt (4).
(14)
Install line (2) on injector pump (3) and tighten fitting nut (1).
4-108
