TM 5-4310-386-14
4-35. Over Flow Return Line.
This task covers:
a.
Replace
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tool Kit
Compressor unit shut down (para. 2-13).
(NSN 5180-00-177-7033)
Materials/Parts
Over Flow Line
Replace. (figure 4-43)
(1)
Remove banjo bolt (1), two washers (2), and remove line (3) from the fuel pump fitting (4).
(2)
Remove nut (5), washer (6), bolt (7), pipe clip (8), and rubber sleeve (9) from end plate (10).
(3)
Remove two banjo bolts (11), five washers (12), and remove line (3) and banjo nut (13) from
injectors (14).
(4)
Loosen screw (15) on clamp (16), and remove line (17).
(5)
Install line (17) on banjo nut (13), and tighten screw (15).
(6)
Install line (3) and banjo nut (13) on injectors (14) and secure with five washers (12) and two banjo
bolts (11).
(7)
Install rubber sleeve (9), pipe clip (8) on end plate (10) and secure with bolt (7), washer (6), and nut
(5)
(8)
Install line (3) on fuel pump fitting (4) and secure with two washers (2) and banjo bolt (1).
4-110
