TM 5-4310-386-14
5-30. Fuel Injection Pump (Cont).
(5)
Remove cover (10), sealing ring (11), and base (12).
(6)
Remove bolt (13) and nut (14).
(7)
Remove dowel pin (15), lever arm (16), lockwasher (17), seal (18), and shaft (19).
(8)
Remove dowel pin (20) and shutdown lever (21).
(9)
Remove nut (22), washer (23), ball socket (24), and stud (25).
(10)
Remove two bolts (26), lockwashers (27), and flange (28).
(11)
Remove angle piece (29), compression spring (30), sealing ring (31), pump element (32), and sealing ring
(33).
(12)
Remove alien screw (34) and sealing ring (35).
(13)
Remove notched nail (36) and cover plate (37).
(14)
Remove notched pin (38), shutdown shaft (39), yoke spring (40), and seal (41).
(15)
Remove cap nut (42), sealing ring (43), nut (44), sealing ring (45), half-moon ring (46), and pin spigot (47).
(16)
Remove dowel pin (48), forked lever (49), spring cap (50), spring (51), and sleeve (52).
(17)
Remove spring cap (53), lockwasher (54), circlip (55), and guide (56), from pin/bolt/stud (57).
(18)
Remove ball bearing (58), lockwasher (59), and ball bearing (60) from pin/bolt/stud (57).
(19)
Remove retaining ring (61), gear (62), and plate (63) from pin/bolt/stud (57).
(20)
Remove half-moon ring (64), bushing (65), flyweight (66), and ball bearing (67) from pin/bolt/stud (57).
(21)
Remove two nuts (68), lockwashers (69), washers (70), from studs (71).
(22)
Remove roller pivot pin (72), roller (73), locking spring (74), and roller tappet bushing (75).
(23)
Remove tappet guide (76), four shims (77), spring cap (78), taper spring (79), support plate (80), piston
guide (81), and two studs (71).
(24)
Remove draw spring (82), nut (83), lockwasher (84), and bolt (85).
(25)
Remove control lever (86), dowel pin (87), spring (88), lever arm (89), and seal (90) from injection pump
housing (91).
5-134
