5-39. Push Rod Tubes.

FOLLOW-ON MAINTENANCE - TM-5-4310-386-14_369

TM-5-4310-386-14 Compressor Reciprocating Air: Electric Motor Driven & CFM 175 PSI C & H Model 20-918 Manual
Page Navigation
356

TM 5-4310-386-14 5-39. Push Rod Tubes. This task covers: Replace INITIAL SETUP Tools Equipment Condition General Mechanic's Tool Kit Compressor unit shut down (para. 2-13). (NSN 5180-00-177-7033) Cylinder head assembly removed (para. 5-39). Tensioning Tool (P/N 003 0501) Materials/Parts Push Rod Tubes Replace. (figure 5-57) NOTE There are two push rod tubes for each head. Replacement of each is the same. (1) Remove top seal (1), push rod tube (2), spring (3), profile washer (4), and bottom sealing ring (5). (2) Using tensioning tool, install spring (3), on push rod tube (2). (3) Install profile washer (4) on bottom of push rod tube (2) with domed side facing spring (3). (4) Install sealing ring (5) on bottom of push rod tube (2) with flat side facing toward the end (bottom) of push rod tube. (5) Install top seal (1) on top of push rod tube (2) with flat side facing toward the shoulder. (6) Install spring end of push rod tube in the crankcase. FOLLOW-ON MAINTENANCE Install cylinder head assembly (para. 5-40). 5-162

Privacy Statement
Press Release
Contact