TM 5-4310-386-14Table 4-2. Unit Troubleshooting Procedures.MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONENGINE1. ENGINE DOES NOT TURN OVER.Step 1. Improper starting procedure.Follow proper starting procedure (para. 2-12).Step 2. Check to see if battery is defective or dead.Recharge or replace (para. 4-45).Step 3. Check to see if cable connections of starter motor circuit are oxidized.Replace cable connections (para. 4-45).Step 4. Check to see if cable connections of starter motor circuit are loose.Tighten connections (para. 4-45).Step 5. Check to see if starter motor is defective or pinion does not engage.Replace starter motor (para. 4-47).Step 6. Check to see if starting aid is defective.Replace starting aid or ensure ether reservoir is full (para. 4-48).2. ENGINE FAILS TO START OR DIFFICULT TO START.Step 1. Improper starting procedure.Follow proper starting procedure (para. 2-12).Step 2. Check to see if engine shutdown lever has been placed in operating position.Place shutdown lever in operating position (para. 2-12).Step 3. Check to see if the speed control lever has been placed in the starting position.Set speed control lever to about one-quarter speed (para. 2-12).4-19
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
