TM 5-4310-386-14
4-19. Controls and Indicators .
This task covers:
Replace
INITIAL SETUP
Tools
Materials/Parts (Cont)
General Mechanic's Tool Kit
Start Switch
(NSN 5180-00-177-7033)
Ammeter
Engine Oil Pressure Gage
Materials/Parts
Temperature Gage
Throttle Control
Hourmeter
Indicator Light
Equipment Condition
Switches (ON/OFF)
Relay Latch
Compressor unit shut down (para. 2-13).
Switch (Engine RUN/STOP)
Replace.
(1) Engine oil pressure gage. (figure 4-10)
(a) Loosen screw (1) on clamp (2) and remove hose (3).
(b) Remove fitting (4) from oil pressure gage (5).
(c) Remove nuts (6), washers (7), and tag and remove three wires (8).
(d) Remove nut (9), washer (10), and bracket (11).
(e) Remove screw (12) and nut (13) and tag and remove two wires (14).
(f) Remove oil pressure gage (5) from control panel (15).
(g) Install oil pressure gage (5), bracket (11), and secure with washer (10) and nut (9).
(h) Install two wires (14) and secure with nut (13) and screw (12).
(i) Install three wires (8), washer (7), and nut (6).
(j) Install fitting (4) on oil pressure gage (5).
(k) Install hose (3) and tighten screw (1) on clamp (2).
4-40
