TM 5-4310-387-14
4-29. Governor Assembly.
This task covers:
a.
Adjust
INITIAL SETUP
Tools
General Mechanic's Tool Kit (NSN 5180-00-177-7033)
Revolution Counter (P/N 84348)
Revolution Counter Insert (P/N 84349)
Adjust. (figure 4-27)
(1)
Remove two screws (1), washers (2), plate (3), and gasket (4).
(2)
Rotate flywheel (5) until weights (6) are split in the vertical position.
(3)
Bend locking tab (7) away from nut (8).
(4)
Loosen nut (8).
(5)
Pry weights (6) as far apart as they will go.
(6)
Screw in screw (9) until it contacts governor pin (10).
(7)
Allow weights to come together.
(8)
Turn screw (9) an additional 1/2 turn in.
(9)
Hold screw (9) and tighten nut (8).
(10)
Bend locking tab (7) to secure nut (8).
(11)
Install plate (3) and gasket (4), and secure with two screws (1) and washers (2).
(12)
Start engine (para. 2-12), allow to reach operating temperature and speed and check speed. Repeat steps
1 through 11 if speed is incorrect.
(13)
Shut engine down (para. 2-12).
4-60