TM 5-4310-387-14
o.
Remove prefilter hose. Seal opening in air filter housing with tape (Item 22, Appendix E).
p.
Service engine inlet air cleaner and refill with preservatives P-10, grade 10 in lieu of engine oil.
q.
Seal engine air cleaner inlet with tape (Item 22, Appendix E).
r.
Drain all fuel from engine fuel tank. Spray interior of fuel tank with 2 to 3 fluid ounces of preservative P-10,
grade 30.
s.
Clean dirt and debris from compressor cooling fins.
t.
Apply preservation P-9 to the exterior surfaces of the engine exhaust manifold, pipe and muffler.
u.
Tag engine with a red tag stating "Caution: Crankcase filled with preservative P-10. Drain and refill with proper
lubricating oil prior to use."
v.
Store in a dry, dust-free room and cover with a plastic film that does not "sweat". Remove cover from time to
time and clean off the unit.
4-49. Preparation for Shipment.
a.
Boxed or Crated Shipment.
(1)
Prepare the unit for storage In accordance with paragraph 4-47 and 4-48.
(2)
Box or crate the complete unit in accordance with local packaging procedures.
b.
Uncrated Shipment. The compressor may be shipped by securing the unit directly to the load surface of a
vehicle such as a truck. The units should be lifted and tied down In accordance with figure 4-38. The
approximate center of gravity of the unit is shown in figure 4-39.
4-89
