TM 5-4310-387-14
5-14.
Final Separator Assembly..
This task covers:
a.
Replace
b.
Repair
INITIAL SETUP
Tools
General Mechanic's Tools Kit (NSN 5180-00-177-7033)
Materials/Parts
Final Separator Assembly
Bags, Plastic (Item 3, Appendix E)
Grease, Halo Carbon (Item 14, Appendix E)
Bands, Rubber (Item 4, Appendix E)
Tape, Pressure Sensitive (Item 22, Appendix E)
Equipment Condition
Compressor unit shutdown and depressurized
(para. 2-12).
Reference
Cleaning Procedures, Chapter 4, Section VI.
a.
Replace. (figure 5-11)
WARNING
Cleanliness is imperative in maintaining and handling diving air system components. All tools
and parts must be kept free of oil, grease, rust, or other contamination in accordance with Chapter
4, Section VI of this manual. Foreign substances within an assembly could result in equipment
failure and possible injury or death to personnel.
Ensure that all air lines and components removed or openings into the air system that provides
breathing air are covered with a plastic bag and secured with a rubber band or taped shut. Small
components should be stored in a plastic bag and sealed. Failure to do so will cause air system to
become contaminated and could result in injury or death to the diver.
(1)
Loosen two connector nuts (1) and remove inlet line (2).
(2)
Loosen connector nut (3) and disconnect outlet line (4).
(3)
Loosen bolt (5) and nut (6) and remove separator (7).
(4)
Remove bolt (8), plate (9), and clamp (10).
(5)
Remove safety valve (11) and seal (12).
(6)
Remove two elbows (13) and drain valve (14).
(7)
Install drain valve (14) and two elbows (13).
(8)
Install clamp (10), plate (9) and bolt (8).
(9)
Install seal (12) and safety valve (11).
5-30
