TM 5-4310-387-14
6-17. Governor Assembly (Cont).
b.
Repair. (figure 6-14)
(1)
Remove governor assembly (para. a.).
(2)
Remove locknut (1), spring (2), spring (3), lock tab (4), spring seat (5), and spring (6).
(3)
Remove locknut (7), spring (8), spring (9), lock tab (10), spring seat (11), and spring (12).
WARNING
Dry cleaning solvent, PD-680 used to clean parts Is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive
heat. Flash point of solvent is 100°F-138°F (38°C-60°C).
(4)
Clean all items with dry cleaning solvent and dry thoroughly.
(5)
Inspect locknuts (1) and (7) and replace if bent, cracked or threads are stripped.
(6)
Inspect springs (2), (3), (6), (8), (9), and (12) and replace all springs if any one of them is cracked, bent, or
deformed in any way.
(7)
Inspect weights (13) and body (14) and replace if weights are cracked, body is cracked, or threads are
stripped.
(8)
Inspect pin (15) and replace if bent or ends are mushroomed.
(9)
Inspect locking tabs (4) and (10). Remove any burrs or deformations in locking tabs (4) and (10). Locking
tabs (4) and (10) are not available as piece parts. Make every effort to reuse locking tabs (4) and (10).
(10)
Inspect spring seats (5) and (11). Spring seats are not available as piece parts. Make every effort to reuse
spring seats (5) and (11).
(11)
Install spring (12), spring seat (11), lock tab (10), spring (9), spring (8) and secure with locknut (7).
(12)
Install spring (6), spring seat (5), lock tab (4), spring (3), spring (2) and secure with locknut (1).
(13)
Install governor assembly (para. a.).
6-44
