TM 5-4310-393-14CHAPTER 5DIRECT SUPPORT MAINTENANCE INSTRUCTIONSPageSection IRepair Parts, Special Tools; Test Measurement and DiagnosticEquipment (TMDE), and Support Equipment ............................................................................... 5-1Section II Direct Support Maintenance Instructions ..................................................................................... 5-1Section I. REPAIR PARTS; SPECIAL TOOLS; TEST MEASUREMENTAND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENTParagraphPage5-1Common Tools and Equipment ................................................................................................... 5-15-2Special Tools (TMDE), and Support Equipment ........................................................................... 5-15-3Repair Parts .............................................................................................................................. 5-15-1.COMMON TOOLS AND EQUIPMENT.For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)applicable to your unit5-2.SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.Refer to Repair Parts and Special Tools List (RPSTL) TM-5-4310-393-24P and the Maintenance Allocation Chartpertaining to direct support maintenance for the CAPITANO-PD Reciprocating Compressor Unit.5-3.REPAIR PARTS.Repair parts are listed and illustrated in the Repair Parts and Special Tools List. TM 5-4310-393-24P for this equipmentSection II. DIRECT SUPPORT MAINTENANCE INSTRUCTIONSParagraphPage5-4General ..................................................................................................................................... 5-15-5Operating Parameters and Tolerances ........................................................................................ 5-15-6Diesel Engine ............................................................................................................................ 5-75-7 Instruments - Gauges............................................................................................................... 5-515-8 Frame Assembly...................................................................................................................... 5-525-4.GENERAL.This chapter will describe maintenance to be performed on the engine and compressor assemblies beyond authorizedcapability of lower levels This chapter contains maintenance at the Direct Support Level as authorized by the MaintenanceAllocation Chart (MAC)5-5.OPERATING PARAMETERS AND TOLERANCES.This section will contain an itemized list of manufacturer's specifications, sizes, and tolerances required for theCAPITANO-PD Reciprocating Compressor Unit5-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
