TM 5-4310-451-14
4-69. REAR WHEEL BEARINGS AND BRAKEDRUM MAINTENANCE (Con’t).
5.
Remove keywasher (5) from spindle (3).
6.
Pull hub (2) out slightly on axle (1) to loosen outer wheel bearing cone (4). Remove outer wheel bearing cone
from hub and spindle.
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless area
has been properly cleaned. There may be asbestos dust on these components
which can be dangerous If you touch It or breathe ft. Wear an approved filter mask
and gloves. Never use compressed air or a dry brush to clean brake components.
Dust may be removed using an Industrial-type vacuum cleaner. Clean dust or mud
away from brake components with water and a wet, soft brush or cloth. Failure to
follow this warning may result In serious Illness or death to personnel.
7.
Remove hub (2) and brakedrum (9) from axle
(1).
8.
Remove oil seal (10) and inner wheel bearing
cone (11) from hub (2). Discard oil seal
TA704821
4-163
