TM 5-4310-451-14
Section XV. STEERING SYSTEM MAINTENANCE
Paragraph
Page
Number
Paragraph Title
Number
4-70
Steering Knuckle Replacement ...................................................................................
4-169
4-71
Steering Arm Replacement .........................................................................................
4-172
4-72
Tie-rod Maintenance....................................................................................................
4-175
4-70. STEERING KNUCKLE REPLACEMENT.
This Task Covers:
a
Removal
c
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
Hub and wheel bearings removed (see para-
Dry cleaning solvent (item 38, Appendix E)
graph 4-68)
One cotter pin
One spring pin
Tools/Test Equipment:
General mechanic's tool kit
General Safety Instructions:
Common no. 1 shop set
Dry cleaning solvent is flammable and must not
be used near open flame. Use only in a well-
ventilated area.
a.
REMOVAL
1.
Remove cotter pin (2), slotted nut (1), and tie-rod end (4) from steering knuckle (3). Discard cotter pin.
4-169