TM 5-4310-451-14
5-10. LINES AND PORTS (Cont).
(2)
Cover, cap, plug, or tape lines and ports after disconnecting lines. When these are not available, use
handcarved wooden plugs, clean rags (Item 35, Appendix E), duct tape (Item 42, Appendix E), or other similar materials to
prevent dirt from entering system.
(3)
Ensure that new and used parts are clean before installing.
(4)
Wait to uncover, uncap, unplug, or remove tape from lines and ports until just before installing lines.
5-11. TUBES AND COMPRESSION FITTINGS.
NOTE
Use this procedure to assemble compression fittings on engine fuel lines.
Refer to Appendix F for Instructions on manufacturing engine fuel lines.
a.
Slide nonmetallic hose inside compression sleeve of tapered fitting until hose reaches stop in sleeve.
b.
Twist tapered fitting inside end of hose and tighten against hose. This forces hose against threads of
compression sleeve and forms a seal.
5-12.
FLUID DISPOSAL.
Dispose of contaminated drained fluids in accordance with the Standard Operating Procedures (SOP) of your unit.
5-10